Carvers.it

Gorilla tape is like duct tape?

Inviato dal mio SM-G935F utilizzando Tapatalk

pokkis wrote: ↑05/09/2018, 19:23 If you worry screws opening, you can put Gorilla tape over them so they dont open too much, or get lost.

I don't think that the Gorilla tape is the solution. I Think the gorilla tape doesn't work. When you carve, the slow screw ruins the thread, even if it is not lost.

JaX wrote: ↑05/09/2018, 19:41 Gorilla tape is like duct tape?

Inviato dal mio SM-G935F utilizzando Tapatalk

Yes but with very tough with very good clue.
I have had problems with screws opening on my VistFlex, and that has been my fix.
I put piece of tape over screw end (not in thread) and that keeps screw not open (at least not too much).
Loctite, or similar, would be simpler, but due i change plates quite often, it is not good for me.

pokkis wrote:

JaX wrote: ↑05/09/2018, 19:41 Gorilla tape is like duct tape?

Inviato dal mio SM-G935F utilizzando Tapatalk

Yes but with very tough with very good clue.
I have had problems with screws opening on my VistFlex, and that has been my fix.
I put piece of tape over screw end (not in thread) and that keeps screw not open (at least not too much).
Loctite, or similar, would be simpler, but due i change plates quite often, it is not good for me.

This works on both feet or only the fixed one?
Do it last even under the sliding boot?

Inviato dal mio SM-G935F utilizzando Tapatalk

On VistFlex both ends slide.

pokkis wrote:On VistFlex both ends slide.

I have seen it only in photo and not the hinges.

Inviato dal mio SM-G935F utilizzando Tapatalk

It is fixed to board at both ends like basic Vist